Utility exclusive shaft that is thick, strong, sharply deflected
Set the tip diameter to the iron diameter (9.4 mm), eliminate the backswing, shake at the impact as much as possible, suppress the excessive blowing and overtaking, UT dedicated shaft aimed for straightness.
- Basically there is no need for chip cutting about the shaft cutting method. When using it for FW etc., please adjust the hardness within the range where the insertion length into the hosel + tip cutting does not exceed the parallel length of the shaft front end part.
- Please be aware that inserting into the hosel beyond the parallel length to the shaft tip end, inserting it into the hosel after cutting the tip end of the shaft more than the painted surface may lead to breakage of the shaft.
- Please be careful because it will cause shaft crack if tightening the shaft too strongly when assembling the club, measuring the frequency, changing the grip, etc.